 | | | Debugging v2 components targetted to Flash 6 player | Debugging v2 components targetted to Flash 6 player
2004-02-19 - By Jonathan Kaye
Back
Hello!
I 've just completed an overhaul of my component set to the v2 architecture,
and even though it 's designed to be used in Flash 7 (and hopefully beyond!),
for kicks I tried publishing to Flash 6, AS 2. I had followed the
instructions to do this by defining clip parameters, but when I publish to
the Flash 6 AS 2 target, some of the functionality doesn 't work. It seems
to revolve around properties that should have been set through
getter/setters. For example, the audio click linkage ID I supply through a
getter/setter works fine in FP 7 but doesn 't work in FP 6.
Anyone have tips for diagnosing these kinds of problems? The only other
thing I can think of is that I use 1 or 2 layers of subclasses, and I put
the superclass properties into the clipParameters for the component.
Any help is appreciated!
-jonathan
Jonathan Kaye, PhD
President, Amethyst Research LLC
Leaders in Interactive Simulation
www.amethystinteractive.com
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
Supported by Fig Leaf Software
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
Be sure to check the archives and the wiki:
http://chattyfig.figleaf.com/
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
http://chattyfig.figleaf.com/cgi-bin/ezmlm-cgi?1:mss:104750
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
To unsubscribe send a blank e-mail to:
Normal Mode: flashcoders-unsubscribe@(protected)
Digest Mode: flashcoders-digest-unsubscrive@(protected)
|
|
|