 | | | AW: [Flashcoders] Switch/Case vs If/else | AW: [Flashcoders] Switch/Case vs If/else
2004-02-11 - By Mees, Stefan
Back
i think to remember that switch/case is in byte code the same result than
If/Else... the only difference is better looking source code..
Best, Stefan
-- --Ursprüngliche Nachricht-- --
Von: Andreas SJ [mailto:broken@(protected)]
Gesendet: Mittwoch, 11. Februar 2004 10:07
An: flashcoders@(protected)
Betreff: [Flashcoders] Switch/Case vs If/else
Is switch/case faster than if/else?
- Andreas SJ
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
Supported by Fig Leaf Software
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
Be sure to check the archives and the wiki:
http://chattyfig.figleaf.com/
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
http://chattyfig.figleaf.com/cgi-bin/ezmlm-cgi?1:mss:103757
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
To unsubscribe send a blank e-mail to:
Normal Mode: flashcoders-unsubscribe@(protected)
Digest Mode: flashcoders-digest-unsubscrive@(protected)
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
Supported by Fig Leaf Software
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
Be sure to check the archives and the wiki:
http://chattyfig.figleaf.com/
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
http://chattyfig.figleaf.com/cgi-bin/ezmlm-cgi?1:mss:103758
=-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
To unsubscribe send a blank e-mail to:
Normal Mode: flashcoders-unsubscribe@(protected)
Digest Mode: flashcoders-digest-unsubscrive@(protected)
|
|
|